
Then, about 15 minutes later, when I had calmed down, I thought I remembered flushing her down the toilet. Had she died and I'd forgotten? no......well, wait a minute- I think maybe I HAD lost an albino a week before!
Whew!!

So, I went about my way and about a week went by when I noticed one of my other albinos was acting funny. So, I lifted the tank's cover off and inspected the heater......where I found my missing female albino! She was quite bloated and had floated into the heater and then up to the surface! Seems she had been decaying in there all that time, thus slowly increasing the water's nitrate level- to a very dangerous level! But, because of my MS fatigue that day, I wasn't able to do a half water change until the next day. Well, by the time the next day came- three of my four albino corycats were dead.

I am now down to only two cory aneaus,one albino and one male betta plakat.
My question is this: I have never really understood the difference between water's TOTAL HARDNESS (GH) and water's TOTAL ALKALINITY (KH). But now that I've done this 3/4 water change: the water testing indicates that I have a GH of 25ppm (very soft) and a KH of 40ppm (the ideal for freshwater is between 120ppm and 300ppm. So, how do I go about RAISING the KH??? Now, I know that the fish I have prefer a more acidic water pH, so what can I do to help KEEP the pH level in the desired pH level of 6.2-6.8???
Thank you so much for any help you can give!
-Baba